Hello I bought the usb yoke adapter It show up in windows 7 test to be fine but when I try it on star wars the cursor is in the bottom left hand corner Also it says in the instructions when you power on the machine the yoke will turn to each corner to calibrate my doesn't move Have I done something wrong Thank you Quick update after adjusting the gears inside my original yoke I now have the cursor almost centre But I'm still confused about this bit in the instructions On each power up, the Yoke Controller enters the calibration state, which typically results in the controller acting erratically, moving the yoke in all 4 maximum directions calibrates the controller. Does anyone using this adapter with a PC does the yoke move on it's own when your pc boots up mine doesn't Thanks again Hello I bought the usb yoke adapter It show up in windows 7 test to be fine but when I try it on star wars the cursor is in the bottom left hand corner Also it says in the instructions when you power on the machine the yoke will turn to each corner to calibrate my doesn't move Have I done something wrong Thank you Quick update after adjusting the gears inside my original yoke I now have the cursor almost centre But I'm still confused about this bit in the instructions On each power up, the Yoke Controller enters the calibration state, which typically results in the controller acting erratically, moving the yoke in all 4 maximum directions calibrates the controller. Does anyone using this adapter with a PC does the yoke move on it's own when your pc boots up mine doesn't Thanks againUSB adapter